JP Enterprises Low Profile Adjustable Gas Block - .750
Sign up to be notified when this is back in stock
Email Address*
Mobile Number*
By entering your mobile number above, you consent to receive Rainier Arms back-in-stock text notifications from 35657 to that number. Msg frequency may vary. Msg & data rates may apply. Reply HELP for help and STOP to cancel. See Terms and Conditions & Privacy Policy
The JPGS-5B model is our minimized small bore design intended to mount underneath many hand guard models on the market.
This model also now includes our locking adjustment feature, which consists of an integral brass set screw that can be tensioned against the adjustment screw after it has been set to prevent any migration that might occur.
Full coverage around gas port providing improved seal and better heat dissipation
True clamp-on design with four positive clamping screws
Easy to access side gas adjustment
Specifications:
Barrel Diameter: .750
Material: 416 stainless
Finish: Black
Weight: 2.25 oz.
Length: 1.28"
Height: 1.40" (overall), .78" (over bore)
Width: .89"
Attachment: 6-32 x 1/2" socket head screws, T15 Torx drive (included) (includes 5/64 x 5/16 roll pin for gas tube installation)
Adjustment: 6-32 x 3/8" set screw, 1/16 hex drive (included)
Review by Harry W. on 12 Mar 2021review stating Nice item but wasted my money
Installed this because my Ar10 was short stroking and would not load next round. So it was suggested to try an adjustable gas block. After installing the JP gas block there was no change. Last resort was to drill out the gas port hole larger. Once we did that everything started working as it should did not need the adjustable one. Oh well gues...Read MoreRead more about Installed this because my Ar10 was
s I will chalk that up as a lesson learned and now have an adjustable gas block in case I ever need one. Read LessRead less about Installed this because my Ar10 was
Review by Harry W. on 12 Mar 2021review stating Nice item but wasted my money
Installed this because my Ar10 was short stroking and would not load next round. So it was suggested to try an adjustable gas block. After installing the JP gas block there was no change. Last resort was to drill out the gas port hole larger. Once we did that everything started working as it should did not need the adjustable one. Oh well gues...Read MoreRead more about Installed this because my Ar10 was
s I will chalk that up as a lesson learned and now have an adjustable gas block in case I ever need one. Read LessRead less about Installed this because my Ar10 was
